![]() What you're really after in order to make it quiet is perfect laminar flow along a surface.īTW - the BeanAnimal overflow is a really good design. new 125 gallon non-reef ready Aqueon tank. I would highly recommend him to anyone interested in having a really nice setup. Once I get the tank going, Ill be sure to add pics. A thinner outer box may be something to consider, if you have limited space behind the tank. Another option is two seperate herbies, or one herbie one closed loop. You need to tie the two lines together using a larger pipe diameter in order to balance the two overflows. Technically this is more a herbie than bean. This eliminates having to use bulkheads with large flanges. Only tie two together, the durso pipe and/or emergency isnt tied into the siphon. If you add slots on top of your current weir that will almost certainly make it noisier by raising the water level slightly in the DT and adding turbulence. So far Ive got: - amazing custom-made solid oak, black stand and canopy built by Jim who is here on Boston Reefers (Calciumbuf). The Synergy Shadow and Ghost Overflows also do not use bulkheads in the outer box, so the outer box can be slimmer. If you cut slots, that would accomplish the same thing as #1 (by lowering the water in the tank some) but can add turbulence to the flow into the overflow box that could end up making it noisier (or not. So first and foremost, a Bean Animal drain setup has a Main siphon, secondary drain and emergency drain. I was thinking since it was set up of doing the bean animal overflow. (You can play with the effect of this by finding the spot with the largest stream of water and sticking your finger in at an angle so that the water follows your finger - to see the effect it can have.) I recently got a new frag tank, it came with an external overflow with 3 1' holes. Give the water a sloped surface to "stick" to via surface tension so that it doesn't splash down - getting this to work is tricky and you have little space for it. Decrease the rate of flow through your sump/filter (which will decrease the amount of water going over the weir and possibly allow the water to "stick" (surface tension) to the side of the overflow box without breaking away and splashing.ģ. (Yeah, I know, that means modifying your standpipes. Raise the water level inside the overflow box so that the water flowing over doesn't fall as far. This is a weir-type overflow (as opposed to the slotted sort).ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |